Start a new topic

ML605 and FMC110 will not communicate over Ethernet port

I am trying to follow the "getting started" procedure for an FMC110 board and an ML605 FPGA board.  The bit file ml605_fmc110.bit loads, and the 4FM FMC Analyzer program recognizes the FMC card and the Carrier.  However, when I click the "open device" button, I get an error that says there "Unable to connect to FPGA" and a cmd window that says "Could not obtain sipcid table (error ffffffff)".  None of the LEDs near the Ethernet port on the ML605 are on or blinking.
I saw a similar post in this forum suggesting that I should use a different bit file, 363_ml605_fmc16.bit.  That bit file has the same symptoms.

This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.
Dear Tim,


Have you got that issue resolved?


Best Regards,
Arnaud