Hello, I would like to ask a question about the daughter board FMC30RF, being used with a ZC702: (I started working recently in FPGA design) How should I integrate the BSP from this board in any Vivado/ISE project? I know this question is too vague, so I'll try to clarify.
I already read and tried your "4DSP getting started guide" and used the corresponding BSP for this set (ZC702+board) and read the manuals. However, I didn't understand if it's possible to create, for example, an IP for this daughter board from that to integrate on any Vivado/ISE block design, or if I have to do this only in VHDL/Verilog?
The StellarIP can create an ISE project based on the design made in it; is the integration as simple as including this project inside another project, or is it beyond this? Also, the source code you give (from FMC30RFapp) should be included afterwards?
I want to put the ZC702 acquiring/sending signals from FMC30RF and doing other things apart from this that are non-related with the FMC. I know that you do not offer support to Vivado in this set, but if you still could answer me, I would be grateful.
I would appreciate any help. Thank you for your time. Best regards, Joao
1) Use StellarIP to generate an ISE firmware and modify the firmware by adding VHDL/Verilog sources. 2) Create a star and get StellarIP add it in the ISE firmware.
The 4FM Getting Started Guide covers creating a custom star, for 2) and 1) should be no problem, creating and modifying firmware in ISE Navigator is a standard firmware engineering duty.
I hope that helps!
Best Regards, Arnaud
C
Customer
said
over 8 years ago
Ok, I'll check that (I think I was a little bit lost in the beginning).
Thank you for your time, Joao
4DSP Support
said
over 8 years ago
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.
Customer
I would like to ask a question about the daughter board FMC30RF, being used with a ZC702: (I started working recently in FPGA design)
How should I integrate the BSP from this board in any Vivado/ISE project? I know this question is too vague, so I'll try to clarify.
I already read and tried your "4DSP getting started guide" and used the corresponding BSP for this set (ZC702+board) and read the manuals. However, I didn't understand if it's possible to create, for example, an IP for this daughter board from that to integrate on any Vivado/ISE block design, or if I have to do this only in VHDL/Verilog?
The StellarIP can create an ISE project based on the design made in it; is the integration as simple as including this project inside another project, or is it beyond this? Also, the source code you give (from FMC30RFapp) should be included afterwards?
I want to put the ZC702 acquiring/sending signals from FMC30RF and doing other things apart from this that are non-related with the FMC. I know that you do not offer support to Vivado in this set, but if you still could answer me, I would be grateful.
I would appreciate any help. Thank you for your time.
Best regards,
Joao
1 person has this question