the following document CD275 KC705+FMC176 FMC176 Reference Firmware For KC705
stated the following state men
4.1 Setting up the simulation In order to setup the simulation, perform the following steps: - Start with the creation of the ISE project. Refer to the StellarIP section in the 4FM Getting Started Guide. - Use ISE to open the project from[b][i][u] “\275_kc705_fmc176\output[/u][/i][/b]\ kc705_ fmc176”. problem is [b][i][u] “\275_kc705_fmc176\output [/u][/i][/b][b]is empty and there is no project [/b]
1 Comment
4DSP Support
said
over 8 years ago
Dear Sir, Have you actually ran StellarIP? StellarIP is creating the Xilinx project and the simulation environment. Best Regards, Arnaud
Customer
CD275 KC705+FMC176
FMC176
Reference Firmware
For KC705
stated the following state men
4.1 Setting up the simulation
In order to setup the simulation, perform the following steps:
- Start with the creation of the ISE project. Refer to the StellarIP section in the 4FM
Getting Started Guide.
- Use ISE to open the project from[b][i][u] “\275_kc705_fmc176\output[/u][/i][/b]\ kc705_ fmc176”.
problem is
[b][i][u] “\275_kc705_fmc176\output [/u][/i][/b][b]is empty and there is no project
[/b]