I am following the steps of 4FM Getting Started Guide. The section 2.4, Software Requirements (Modelsim...) talks about configuring the Modelsim. In the ISE 14.4 that comes with my KC705 the simulation lib. compilation wizard is under the ISE Design Tools, 32 bit tools. But when I start it I am getting the attached tab. Please advice how to proceed with the configuration.
1 Comment
4DSP Support
said
over 8 years ago
Dear Sir,
We are phasing out modelsim because its price is ridiculous. For instance, the simulation is now done in ISIM typically for FMC30RF.
You can check the constellation documentation found in the firmware source code. There is the steps required for ISIM simulation described in there.
Customer